Enmet ISA-40M Manuale Utente Scaricare il pdf (Pagina 16)

ENMET Corporation ISA-40M Oxygen Monitor

6.0 ISA-40M Specifications6.0 ISA-40M Specifications

Control Unit Specifications

Power 110 VAC (or 220 VAC if transformer standouts are reconfigured),

50/60 Hz, and/or 12 VDC, 20 watts max. (5 watts per channel)

Alarm Horn and red LEDs on Control Unit.

Sensor Lifetime Approximately 14 months.

Warranted for 6 months from date of shipment.

Electronics Low power, all solid state, utilizing integrated circuits.

Dimensions 12" high x 8" wide x 7" deep

Weight 20 lbs.

Enclosure NEMA-4X Fiberglass

Oxygen Cell Specifications

Application General. Intermediate life and response time.

Response Time

90% in 15 seconds, at 25°C (typical)

Output

Nominal (in air at 25°C) 175 ± 5uA

At 0% Oxygen less than 2.0uA

Linearity error (0 – 100% Oxygen) less than 0.5%

Operating Temp. Range

32°F to 125°F

ENMET Warranty 6 months form shipment

Size

1.25″ diameter by 0.80″ long

Weight 26 grams

Expected Life Up to 14 months in air

NOTE: All specifications stated in this manual may change without notice.

7.0 Service Information7.0 Service Information

7.1 Replacement Part Numbers

A full set of replacement part numbers and prices are a part of the documentation which accompanied the order. A

partial list of the most likely parts needed to maintain the equipment is as follows:

ENMET Part Number Description

67013-008

Oxygen Cell, S2, that has a grey label;

The p/n is for the packaged cell as furnished for a replacement

03296-209 24 liter, 240 psi cylinder of 20.9% oxygen in nitrogen

03296-170 24 liter, 240 psi cylinder of 17% oxygen in nitrogen

63001-002 14 VDC lamp

03600-002 Assembly, Calibrator

04537-005 Circuit board, one channel

04537-007 Circuit board, two channel

64002-050 Fuse, 0.05 Amp, 5x20 slow blow

66017-009 Sensor cable, specify length

1 2 ... 11 12 13 14 15 16 17 18

Commenti su questo manuale

Nessun commento

Enmet ISA-40M Manuale Utente Pagina 16

Commenti su questo manuale

Prodotti e manuali riguardandi Strumenti di misura Enmet ISA-40M